Hardy ANY-WEIGH Bench Scales Manuel d'utilisateur télécharger pdf (Page 20)

Any-Weigh™ Series Bench Scales

4-2

Accessing the DIP

Switch

Tilt the scale up until you can reach the DIP Switch

access port or if it is more convenient turn the scale

upside down so that bottom is facing up to reach the

DIP Switch access port.

NOTE: Scale must be connected to earth ground from the

Chassis Ground Attachment Point. (See Fig. 4-1)

Configuring the

Baud Rate

Refer to Table 4-1 to configure the baud rate. 0 = OFF,

1 = ON (* is the default setting)

FIG. 4-2 FACTORY DEFAULT DIP SWITCH CONFIGURATION

Configuring the

DeviceNet Node

Address

Refer to Table 4-2 to configure the DeviceNet Node

Address.

Baud Rate S1-7 S1-8

125 kbps* OFF OFF

250 kbps OFF ON

500 kbps ON OFF

500 kbps ON ON

Table 4-1: Baud Rate

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Pas de commentaire

Hardy ANY-WEIGH Bench Scales Manuel d'utilisateur Page 20