Hardy ANY-WEIGH Bench Scales Manuel d'utilisateur télécharger pdf (Page 30)

Any-Weigh™ Series Bench Scales

6-2

THE BUTTON

Enables one-touch electronic calibration of the scale

when it is empty. Access to THE BUTTON and asso

ciated Module LED is located at the bottom of the

scale through an access port. (See Fig. 6-1)

FIG. 6-1 THE BUTTON LOCATION/BOTTOM

VIEW

Step 1. Make sure that there is nothing in the ves-

sel or on the scale.

Step 2. Check to be sure that the Module LED is

green.

•If the Module LED is NOT green do

not complete the calibration.

•If the Module LED is Green go on to

Step 3.

Step 3. Press and hold the Red Button until the

Module LED goes off. Keeping holding

THE BUTTON down until the Module

LED comes back on.

Step 4. When the Module Status LED comes back

on. Release the RED BUTTON. The

weigh module system is calibrated.

Step 5. If the LED does not come back on contact

Hardy Technical Support for assistance.

Calibration

from

RS NetWorx

Step 1. On the PC Desktop, open RS NetWorx

Step 2. Browse the Network.

Connector

The Button

Dip Switch

Module LED

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 49 50

Pas de commentaire

Hardy ANY-WEIGH Bench Scales Manuel d'utilisateur Page 30